I have two dishes installed, using a single downlead via the pulse switch ref. 7431.
When I change the channel within one satellite using the "step through programmes" button , sometimes the dish being used switches over to the other one.
Is there any way to avoid this?
The change of dish is caused by the fast change between channels with different polarities within the same satellite.
A good solution is to programme channels with the same polarity and from the same satellite consecutively.
This way, you are avoiding the fast change of polarities that causes this switching of dishes.
To change satellites it is necessary to programme any two even channels with no content.
This programming will cause the necessary polarity change so that the switch, ref. 7431, changes input, going quickly from one channel to another: