Televes Televes
Televes
Language: en | it | pt | es
Televes
Televes
Televes
Televes

F.O. Fusion Splicer Kit Ref.232103

Fri, 19/05/2017
Titulo: 
Fibre Fusion Splicer - Version 280

 What's new:

  • Improvements to the alignment of the fibres before performing the splice.

 How to update the firmware of the unit:

  1. Download the update file and unzip the files in a folder (named 232103).
  2. Access the folder that you have just created (232103). Go into the subfolder "Software" and then into “ftdi_ft232_drive”. Run the file found in this folder(ftdi_ft232_drive.exe).
  3. Conect the splicer Ref.232103 to a USB port in your PC or laptop (USB cable not included with the splicer).
  4. Turn on the splicer (make sure that the battery is fully charged).
  5. Access the 232103 folder in your PC or laptop again. Go into the subfolder "Software" and run the file: “OptionFiberFusing.exe”.
  6. Once in this program is running, select the correct COM port, within the options in “Com Rate”. Then introduce the "Baudrate" value (you can check it in the splicer in the "Settings" menu). Press "Connect" (check that indicator in the left bottom corner of the program turns from red to blue).
  7. Select the "Firmware" tab.
  8. Press “Browse” and select the update file (FS135_V280.bin). Press “Send". Please don't disconnect or press any buttons on the splicer whilst the process takes place until the percentage reaches 100% and you get the message on the screen: “Update Finish”. At this point the splicer will start beeping. Disconnect the battery and connect it back again.
  9. The machine is now updated, but you will need to restore the factory default settings. In order to do that, press “Mene”--> “Settings”-->”Factory Settings”--> introduce the password AAAAAAAA. You must then access each of the 6 options, and confirm that you want to restore the factory settings for each of them.
Televes
Televes Televes