The wishlist name can't be left blank
PicoKom power supply for SATmix

PicoKom power supply for SATmix

PicoKom power supply unit

24 V - 130 mA, 2 outputs

Domestic 24 V-power supply (130 mA) that powers equipment through the input coaxial cable while allowing the transmission of the TV signal. Included in the installation to power either mast amplifiers or a BOSS system. Furthermore, it is equipped with two outputs.

Ref. 5795
Generate PDF
EAN13: 8424450140925
SKU
5795
Highlights
  • High-performance switched-mode power supply: saves up to 40% power consumption
  • Very low power consumption
  • Pleasing design and ultra-small size: can be installed in 100 mm x 100 mm connection boxes
  • EasyF connection system
  • Fully automated manufacturing, subject to the most stringent quality controls

Main features
  • Can be wall-mounted using screws
  • Through losses may vary depending on whether 1 or 2 outputs are used

Discover

EasyF connection system: simplicity and savings

EasyF is an innovative connection concept where the inner conductor of the coaxial cable is directly inserted in the device, thus improving connection reliability. Thanks to the absence of F connectors, the chassis can be reduced and the connection of two cables secured with a a single screw.

  • Real time savings: speeding the installation is possible without the need for coaxial cable termination. Furthermore, there is no need for screwing the connectors on the device, which is sometimes difficult when there is little room
  • Connection reliability: the clamp holding the cables prevents the coaxial cable to come off
  • Cost savings: no additional connectors are required (neither F nor IEC)
  • Space optimization: inputs and outputs are always on the same side of the device to prevent coaxial cables from bending, and to make working inside cabinets and register boxes easier
  • Very easy three-step mounting: only screwing and unscrewing the covers is required to connect both cables:

1. Unscrew the device's cover to access the connection

2. Insert the previously stripped coaxial cables

3. Close the cover and screw to ensure connection

Learn more about EasyF system reliability

With EasyF, the connection between the coaxial cable and the device is carried out using an automated system for contact insertion of the inner conductor, without any soldering.

  • Always as new: the device's operating life increases when the factor of solder wearing out with time is removed
  • Failure rate reduction: usually produced as a result of cold soldering joints
  • Electromagnetic behaviour optimization: for high frequencies
  • Our commitment with environment is reinforced: pollution caused by the welding process is eliminated and production power consumption is reduced

Outputs 2
Frequency margin MHz 5 ... 862
Insertion loss MIN dB -1.5
MAX -4
Power supply
Vdc 24
Max. current inputs
mA 130
Mains voltage/frequency
V~/Hz 196 ··· 264 / 50 - 60
Total AC consumption W 4.4
Protection Level IP 20
Temperature operat. limits ºC -5 ... +45

Any 12 V or 24 V power supply unit may be used to feed a DAT HD BOSS antenna.
Not always. Among the devices provided with the Dinova antenna, there is actually a power supply unit. In case of an installation that includes distribution, an active power supply may be required, since the gain it provides allows for the distribution of the signal towards multiple reception points. However, for installations involving just a receiver and an adapter (portable installations), a zAs adapter could power the Dinova antenna without the need for an extra power supply.