The wishlist name can't be left blank

Optical LNB offset

One 1310 nm output: Hh/Vh/Hl/Vl

Optical LNB converter that receives a satellite signal (4 polarity/band combinations) and transmits it over a single fibre. A local oscillator transforms the satellite frequency into an intermediate frequency in the 950 MHz-5.45 GHz range.
Signal is transmitted on the1310 nm wavelength.
The LNB is powered by a coaxial input (F connector) and a 12 V power supply (provided with the product).

The LNB is supplied in grey colour and individual packing.

In stock
Grouped product items
Ref. 2353 32 converters
Generate PDF
  • Output wavelength: 1310 nm
  • High gain
  • Low noise figure
  • Outstanding linearity and careful equalization
  • High discrimination between polarities
  • Very high IP protection index (IP66)
  • Can be used under extreme temperature conditions

Main features
  • FC/PC optical connector
  • Light-weight
  • Low power consumption
  • Power feeding either through the receiver or the multiswitch
  • Simple connection

Technical specifications
Input Frequency GHz 10.7 - 12.75
Output Frequency GHz 0.95 - 5.45
L.O. Frecuency vertical GHz 9.75
L.O. Frecuency horizontal GHz 7.30
Modulated Laser Output nm 1310
Optical Output Power dBm 7 nominal at 25ºC (± 2dBm over full temperature range)
Noise Figure (Typical at 25ºC) dB 0.5
Gain dB 72(gain variation over temperature range)
(-30 ... +60C) ±2dB
Phase Noise Offset frequency Maximum limit
1KHz -55 dBc/Hz
10KHz -80 dBc/Hz
100KHz -100 dBc/Hz
1MHz -110 dBc/Hz
Local Oscillator Stability MHz ± 2
Cross Polar Isolation dB Typ. 30 (min. 25)
Ambient operating temperature range ºC -30 to 60
Storage temperature range ºC -40 to 70

The Optical Fibre interface installed in the H45 or H60 field strength meters allows you to perform optical measurements directly through the optical fibre. It can be powered by connecting a coaxial cable in parallel with the FO to the RF input of the meter and applying voltage like a regular LNB.
No. LNB power supply is always provided in parallel with the fiber. The optical LNB is powered through a coaxial cable. Hence, Optical LNBs are always equipped with two connectors: one “F” for the power supply, and an FC/PC connector for the optical fiber.
It is a plug&play range. The whole range of products is currently available (pre-terminated patch cords, splitters, attenuators, terrestrial and satellite signal mixers...). A full range of products that will help the installer provide closed quotes to their clients.